Installation Guide

How to reverse the crank handle for the model 704/705

Tools Needed: Allen wrench,

hex screw driver or flat head

screw driver and channel locks

or vice grips.

Step 1: Loosen black plastic locking ring on shaft of swivel. Loosen hex nut on left side (located on the inside of

the reel). **DO NOT REMOVE HEX SCREW** This is very difficult to reattach. The shaft of the swivel will

have to be unscrewed from elbow. Hold the elbow when unscrewing swivel shaft and remove swi

vel from t

he left

side of reel. If you are not able to hold the shaft effectively to unscrew from reel’s elbow (located on the inside of

the reel) you will have to remove the brass square head of swivel.

**Removing brass square to swivel: Remove “C” clip from end of square brass swivel (located on the left side of

the reel). This will allow you to hold the shaft effectively when you unscrew the reel.

Step 2: Remove swivel from reel.

Swivel

Elbow

Crank handle

Hex nut

Hold the elbow stationary to unthread the swivel

GARDEN

™

PAGE 1
GARDEN ™ How to reverse the crank handle for the model 704/705 Tools Needed: Allen wrench, hex screw driver or flat head screw driver and channel locks or vice grips. Swivel Elbow Crank handle Step 1: Loosen black plastic locking ring on shaft of swivel. Loosen hex nut on left side (located on the inside of the reel). **DO NOT REMOVE HEX SCREW** This is very difficult to reattach. The shaft of the swivel will have to be unscrewed from elbow.
PAGE 2
Step 3: Remove bolt and washer from crank handle and remove the crank handle (located on the right side of reel) from shaft. Step 4: Loosen hex screw from crank handle shaft (located on the inside of the reel) **DO NOT REMOVE THIS HEX SCREW** Step 5: Loosen black plastic locking ring and remove shaft to crank handle. Step 6: Reel should now be easily removed from frame. Step 7: When the reel is turned, the elbow will now be on the right side of the reel.