User's Manual

-40-
Device Installation
Once the anchor is totally inserted, make sure that it is at least 12 mm below the ground. Then take a sharp punch
(few mm), put it inside the anchor and hit some very hard blows with a hammer.
Figure : Hammering with a punch inside the anchor
<RXVKRXOGQRWLFHWKDWWKHF\OLQGHUZHQWDERXWPPGRZQΖQWKDWPRPHQWWKHDQFKRULQVWDOODWLRQLVȴQLVKHG
LWLVȴ[HGEHFDXVHLWVORZHUZDOOVH[SDQGHG
Figure : Anchor installed
Warning: The anchors provided are indicated for concrete with at least 50 mm of depth, depending on the material of
the terrain where the node is going to be installed, it could be that the anchors are not installed correctly. If the material
RQZKLFKWKHQRGHLVJRLQJWREHDQFKRUHGLVGL΍HUHQWLWPLJKWEHLQWHUHVWLQJWRYDOXHDQDOWHUQDWLYHW\SHRIIDVWHQLQJ
Warning: Make sure that the installation of the anchors is correct. If not, it is possible that the anchorage of the node is
not correct and may even move from its position.