User's Manual

-39-
Device Installation
Step 3:6HWWLQJDQFKRUV7KHDQFKRUVXVHGWRȴ[WKH3OXJ6HQVH6PDUW3DUNLQJDUHPHWDOOLFH[SDQVLRQDQFKRUV
The anchoring mechanism of these anchors is based on the expansion of the metal body against the base material.
This expansion occurs when the expansion cylinder is propelled down, hitting on a punch with a hammer.
First, insert the anchors in the holes and take them all the way down. For that, you can use a hammer and punch of
9 mm in diameter. You can also use a sharper punch to hit on the top circle of the anchor, working on all the circle
as you can see in the following diagram (take care of not hitting inside the anchor to avoid the cylinder goes down).
Figure : Hammering the anchor down
Figure : Good and bad anchor introduction