User's Manual

-38-
Device Installation
Step 2: Drill the holes. Warning: The drill diameter must be 10 mm maximum to prevent the anchor from rotating
freely in the hole. Try to drill as vertical as possible, to enable the best enclosure installation. The length of the
hole must be about 42 mm. It is important to know that the screw will only penetrate to half of the length of the
anchor, so there must be a distance of 12 mm or more between the ground surface and the top of the anchor. You
can experience with slightly deeper holes because the screw does not need to be fully screwed inside the anchor:
depths of 45-50 mm could work too.
Remove all the dust and little rocks inside the 4 holes, created during the drilling operation. This is important to
allow the anchors go all the way down. You can clean each hole mechanically and then use a bottle of spray duster
(high-pressure air bottle). Make sure that the real depth of the hole is enough.
Figure : Drilling the holes
Figure : Section of the hole