User's Manual
Table Of Contents
-20-
6. Updating a New Firmware to MySignals
Using the USB connector, a new rmware version can be uploaded to MySignals without opening the enclosure. Just connect
one side of the USB cable to this connector, removing protection cap if necessary and connect the other side to a PC. Next steps
describe this process in detail.
6.1. MySignals Updater Tool
Step 1: Open the USB connector
Remove the protection cap of the USB connector.
Step 2: Connect the USB cable to MySignals
Connect one side of the male-to-male USB cable to the USB connector.
Step 3: Connect the USB cable to the PC
Connect the other side of the USB cable to your PC.
Step 4: Open MySignals Updater Tool
Now open MySignals Updater Tool. If you do not have MySignals Updater Tool already installed in your PC, then go to the
Development section of Libelium website to download it.
Step 5: Select the corresponding rmware version
Select the rmware version corresponding to MySignals going to tools/board. If you do not have the API for MySignals, please
go to the Development section of Libelium website and download it.
Step 8: Select the USB port
Select the corresponding serial port by going to tools/serial port. If you are unable to see the proper USB port maybe you should
install the latest FTDI drivers on your PC.
Step 9: Upload the rmware
The IDE should say “Done Updated”.
7. Certications Information
This document applies to the following MySignals models, approved for FCC and IC:
Model FCC ID IC
MySygnals XKM-MYSIGNAL-V1 8472A-MYSIGNALV1