Living Smart IoT GateWay Product Manual Model No: SH-GWAYL40A Rev 1.
Table of Contents Page Package Contents …………………………………………………………… 3 Specifications …………………..…………………………………………….. 4 Product Outlook .…………………………………………………………….
Package Contents The package contains the following items I: Living Smart gateway x1 II: USB power cable x 1 (*1) III: Network cable x1 (*1) Note: (*1) Only apply on full set product delivery. Bulk pack delivery with Gateway only.
Specifications Model Number RF Interface RF Output Power Antenna Power Source Ethernet USB Operating Temperature Humidity Size SH-GWAYL40A 802.11 b/g/n Zigbee LL & HA1.2 Protocol +20dBm Internal Antenna 5Volts @ 1000mA RJ45 10/100Mbps USB2.0 or compatible -20 to 70C 95% TH Non-condensing 56 x 56 x 18mm (±0.
Product Outlook Top View WPS Button Page | 5 IoT GateWay
Side View Network Connector DC Power In TBD DC Power in: Use for normal USB output DC adaptor connection (USB power adaptor is not included) Network connector: Connect gateway to router through Network cable USB Port: USB Port This USB port is reserved for further firmware update usage Page | 6 IoT GateWay
LED Status LED 1 (Orange Color) LED 2 (Blue Color) LED1: (Status Indicator) Orange Color: Gateway is ready to use when this indicator become steady LED2: (Connection Status) Red Color: The LAN line connection is using Blue Color: The Wi-Fi connection is using Page | 7 IoT GateWay
Hardware Setup Connection – By LAN cable connection 1) Connect the gateway to your home router by using network cable. *The router should be possible connect to Internet 2) Plug in the mini USB power cable to gateway DC in port. (USB Power adaptor is not included) 3) Connect the USB Power cable to USB power adaptor and plug into your wall power socket. (USB Power adaptor is not included) 4) LED 1 lights up and flashing. 5) When gateway system ready, LED 1 steady.
FCC Caution: This device complies with Part 15 of the FCC rules and Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications or change to this equipment.
