User manual

Installation Manual

Installation

Connecting Cable to the Fan Coil Unit

Connect the wires to the terminals on the control board individually according to the thermostat.

• Ensure that the color of the wires of unit and the terminal No. are the same as those of unit respectively.

The power cord connected to the unit should be

complied with the following specifications (Rubber

insulation, type H05RN-F approved by HAR or SAA).

If the supply cord is damaged, it must be replaced by a special cord or assembly availible from the manufacturer of its service agent.

CAUTION

mm02

LY/NG

NORMAL CROSS-SECTIONAL

AREA 1.0 mm

Install Power Cord

T/B Cover

CAUTION:

Make sure that the screws of the terminal fixed tightly.