Specification

2 of 2
F
E
I
F
I
G
B
A
© 2024 LG Electronics USA, Inc. All rights reserved. “LG Life’s Good” is a registered trademark of LG Corp. All other product and brand names
are trademarks or registered trademarks of their respective owners. Design, features and speci󳣜cations are subject to change without notice.
Non-metric weights and measurements are approximate. Some features may require Internet access. Content and services may vary by product
and are subject to change without notice.
DIMENSIONS / CLEARANCES
TECHNICAL SPECS
Electrical Requirements 120V @ 60Hz
Type Electric
Power Outlet Location Within 60" of Either Side
Plug Type 3-Prong (Cord Attached to Unit)
Min. / Max. Water Pressure 20 - 120 psi
INCLUDED ACCESSORIES
Tie Strap
DIMENSIONS
Product (W x H x D) 27" x 44
11
/
22
" x 28
33
/
88
"
Height with Lid Open 57
11
/
44
"
Cutout Dimensions (W x H x D) 29" x 58" x 32
33
/
88
"
Carton Dimensions (W x H x D) 29
11
/
22
" x 46
55
/
88
" x 31
11
/
44
"
Weight (Product / Carton) 116.9 lbs. / 132.3 lbs.
LIMITED WARRANTY
Parts and Labor 1 Year
Direct Drive Motor 10 Years (Parts Only)
Drum 3 Years (Parts Only)
WT6105C_
3/24
Floor Installation
44 ½"
(113 cm)
27"
(68.6 cm)
1"
(2.5 cm)
1"
(2.5 cm)
57 ¼"
(145.3 cm)
26 ¾"
(68 cm)
28 ⅜"
(72.1 cm)
32"
(81.1 cm)
3 ½"
(9 cm)
Minimum vertical space from floor to overhead shelves,
cabinets, ceilings, etc., is 58 inches (147 cm).
INSTALLATION NOTES
•
•
To ensure sufficient clearance for water lines, the drain
line and airflow, allow minimum clearances of at least 1
inch (2.5 cm) at the sides and 4 inches (10 cm) behind the
unit. Be sure to allow for wall, door, or floor moldings that
may increase the required clearances.
Install the washer on a solid floor that is strong and rigid
enough to support the weight of the washer, even when
fully loaded, without flexing or bouncing. If the floor has
too much flex, you may need to reinforce it to make it
more rigid. If the floor is not solid, it may cause severe
vibration and noise.