Manual

56 TROUBLESHOOTING
Parts & Features
Problem Possible Cause & Solution
Oven control beeps
and displays any F
code error.
Electronic control has detected a fault condition.
• Turn off the oven function you are using to clear the display and stop beeping. Reprogram
oven. If fault recurs, record fault number and contact a service agent.
- Code: F-19
Cause: Oven not heating
k is on in the display
when you want to
cook
The oven door is locked because the temperature inside the oven has not dropped
below the locking temperature.
• Press the STOP button. Allow the oven to cool.
Oven light does not
work.
It is time to replace the bulb or the bulb is loose.
• Replace or tighten bulb. See "Changing the Oven Light" section in this Owner’s Manual.
Cooling fan
continues to run
after oven is turned
off.
The fan turns off automatically when the electronic components have cooled
sufficiently.
• This is normal.
Oven will not Self
Clean.
The oven temperature is too high to set a Self Clean operation.
• Allow the appliance to cool and reset the controls.
Oven controls improperly set.
• See the Self Clean section.
A Self Clean cycle cannot be started if oven door is open.
• Close the oven door.
Oven door does not
open after a Self
Clean cycle
Oven is too hot.
• Allow the oven to cool below locking temperature.
The control and door may be locked.
• Allow about one hour for the oven to cool after the completion of a Self Clean cycle. The
door can be opened when the lock
k is no longer displayed.
The oven is not clean
after a Self Clean
cycle
Oven controls not properly set.
• See the Self Clean section.
Oven was heavily soiled.
• Clean up heavy spillovers before starting the clean cycle. Heavily soiled ovens may need to
Self Clean again or for a longer period of time.
Convection fan stops
(On some models)
Convection fan stops during a convection bake cycle. It is done to allow for more even
heating during the cycle.
• This is not a failure of the range and should be considered normal operation.
Displayed Time is
flashing (On some
models)
This means that the product has just been plugged in, or that it has experienced a
power interruption.
• Touch the Clock key and reset the time, or touch any key to stop the flashing.
Oven racks are
difficult to slide (On
some models)
The shiny, silver-colored racks were cleaned in a Self Clean cycle.
• Apply a small amount of vegetable oil to a paper towel and wipe the edges of the oven
racks with the paper towel.