Owner's Manual

19
HOW TO CHARGE THE BATTERY
Check 1:
If the battery is not charging even when the Robot Cleaner
is attached to the home station, check the following items.

Cleaner off once and then on again.



The Battery level is indicated on the Status Display, as follows.



The status indicators show the
different pending conditions
during charging mode.
※

during the cleaning mode, the Cleaning mode indicator will continue
to flash during charging to indicate that cleaning was disrupted as the
battery required charging.

complete, Robot Cleaner will then resume cleaning the areas which were
not previously completed.

Pressing the 'Start' button on the Remote Controller or 'Start/Stop' button on
main unit whilst it is recharging, with the 'Clean Mode' lamp flashing, will also
manually force the Robot Cleaner to find and clean the uncovered areas.

button on the Robot Cleaner after the Charging has completed will make
the Robot Cleaner start to clean from the beginning again.
Remaining Battery Charge Indicator
If the Battery is Not Charging
Flickering
When there is no existing area
to be cleaned after charging.
When there is an existing area that the
Robot Cleaner will resume cleaning
when charging has completed.
(flashing Cleaning indicator)
Power lamp
Charge terminal
Charging is required
Middle
Low
