Owner's Manual

CLEANING THE SENSOR/CHARGING TERMINAL

Receiving sensor of

remote controller

Camera sensor

• Do not clean the HOM-BOT 2.0 by directly spraying it with water, thinner, benzene, etc.

• Call the service center if the sensor or charging terminal is damaged. Sensor and terminal

damage can cause the product to malfunction.

There are sensors on the HOM-BOT 2.0 that can detect obstacles,

stairways and the home station for charging the battery. In order to

maintain the performance of the HOM-BOT 2.0, regularly clean the sensors

and charging terminal as follows:

1. Lay a smooth cloth on the ﬂoor, overturn the HOM-BOT 2.0 and put it on

the cloth.

※

Please make sure to remove the dust bin before ﬂipping the main body.

Otherwise, the dust in the dust bin may fall out.

2. Turn off the power switch on the bottom of the HOM-BOT 2.0. Injury can

be caused by the activation of the HOM-BOT 2.0 if the main power is

not turned off.

3. Use a smooth cloth or cleaning brush to wipe the dust off each sensor

and the charging terminal as described below.

Charging

terminal

Obstacle detection sensor

Cliff detection sensor

Charging terminal

Bottom camera

sensor

Lens

Tip