Room Air Conditioner OWNER'S MANUAL BE01 ? Please read carefully and thoroughly operating this unit. this manual before ? Contact the authorized SVC man for repair or maintenance of this unit. ? Contact the installer for installation of this unit. ? The is not intended for use by young infirm persons without supervision. children should be supervised to ensure appliance children ? Young that they or do not play with the Prior to appliance.
Safety precautions Safety Precautions Warning ................................2 To prevent injury and property damage, follow these instructions. Incorrect operation due to ignoring instructions will cause harm damage, the seriousness of which is indicated by the following symbols. Caution .................................3 WARNING WARNING Operating Instructions Preparation before ..4 operation or This symbol shows the possibility of death serious or injury. Remote Control Features .....
WARNING WARNING Ventilate before operating air conditioner Do not disassemble when gas goes out. ? It may cause explosion, modify products or ENGLISH randomly. fire and, burn. ? It may cause failure and electric shock. CAUTION CAUTION Never touch the metal of the unit when parts removing Do not clean the air Ventilate well when used conditioner with water. together with a stove, etc. the filter. ? They are sharp injury.
Preparation before operation How to Insert the Batteries Remove the direction. Insert new battery TroubleshtingpCadMcOISfyP CarendMit 4 cover batteries are cover by pulling making sure correctly. installed Reattach the ons battery arrow by sliding it according that the it back into (+) to the and of (-) position. NOTES: ? Use 2 AAA(1.5volt) batteries. Do not use rechargeable batteries. Storage and Tips ? For Using The remote control may be stored on a wall.
LCD Display Operation When the ? user control the unit with remote controller or it is turned on/off displays the operation status. After flowing the description of the status change, it shows the LCD display. (refer to the below table for each mode) by the telephone ENGLISH memory, it ? Remote Control Cooling Start Button Stop Button Operation Model Operation Mode Flow Letter eiaAUNOcaO current Display Caa. mode operation Fixed on Display iei. iOae. 18°e eOUaa ACie Caa.
About the remote control The remote control transmits the signals to the on the system system. Features of the Remote Control- Door Signal transmitter 1 START/STOP BUTTON Operation starts when this button is pressed and stops when the button is pressed again. 2 OPERATION MODE SELECTION BUTTON Used to select the operation mode. 3 TroubleshtingpCadMcOISfyP 6 4 5 3 OFF 7 6 CHAOS SWING BUTTON Used to stop or start louver movement and set the desired up/down airflow direction.
How to use the Operation Mode Selection button Cooling Operation 1 Press the a 2 beep. Open the door on the remote control. To select Cooling Operation, press the Operation Mode Selection button. Each time the button is pressed, the operation mode is shifted in the direction of the Close the door lower than the set within a arrow. Auto Cooling 3 ENGLISH Start/Stop button. respond with The unit will Healthy Dehumidification on Heating (Heat pump model only) the remote control.
Auto Operation 1 Press the a TroubleshtingpCadMcOISfyP 8 2 Start/Stop button. respond with The unit will beep. Open the door on the remote control. To select Auto Operation, press the Operation Mode Selection button. Each time the button is pressed, the operation mode is shifted in the direction of the Auto Cooling 3 The arrow.
Healthy Dehumidification Operation 1 Press the a 2 ENGLISH Start/Stop button. respond with The unit will beep. Open the door the remote control. To select on Dehumidification Operation, press the Healthy Operation Mode Selection button. Each time the button is pressed, shifted in the direction of the Auto Cooling the operation Healthy Dehumidification Set the fan 3 speed again mode is arrow. Heating (Heat pump model only) with the door of the remote control still closed.
Heating Operation(Heat pump 1 Press the TroubleshtingpCadMcOISfyP 10 Start/Stop button. respond with beep. Open the door on Operation, press the remote control. To select the Each time the button Heating Operation Mode Selection button. is pressed, the operation mode is shifted in the direction of the Close the door arrow. Auto Cooling 3 only) The unit will a 2 model Healthy Dehumidification on Heating (Heat pump model only) the remote control.
Jet Cool Operation 1 Press the a 2 beep. Press the Jet Cool button to the will on 3 ENGLISH Start/Stop button. respond with The unit will speed cooling operate mode and the unit operate in super high fan speed cooling mode for 30 minutes. To cancel the Jet Cool mode, press the Jet Cool button or room temperature setting button again and the unit will operate in high fan speed on cooling the fan speed button or the mode.
PLASMA Purification 1 Operation(Optional) Press the Start/Stop button. respond with a The unit will beep. TroubleshtingpCadMcOISfyP 12 2 3 Open the door on the remote control. Press the PLASMA air purifying operation ON/OFF button. Operation will start when the button is pressed and stop when the button is pressed again. Set the fan speed again closed. You can medium, high button is or PLASMA with door of the remote control select the fan speed in four steps-low, CHAOS.
Additional features Mode Sleep 1 Press the Sleep Sleep Mode, press the sleep Mode Auto button several times until the star automatically. ( 2 programmed in one-hour by pressing the Sleep Mode ) disappears increments The Auto operation display. Note: The Sleep Mode will be operated at speed (cooling) or medium fan speed (heat pump only) for quiet sleeping. the slow fan mode is available for 1 to 7 times.
Vertical Airflow Direction Control The up/down airflow (Vertical Airflow) adjusted by using the remote control. be can Note: If you press the CHAOS swing button, the horizontal airflow direction is changed automatically based on the CHAOS algorithm to distribute the air in the room evenly and TroubleshtingpCadMcOISfyP 14 at the time to make the human body enjoying a natural breeze. Always use the remote control to adjust the up/down airflow direction.
Auto restart In the power comes on again after ENGLISH power failure, Auto Restarting Operation is the function to previous operating conditions. So there is no need of activating this function by pressing any key or button. In the initial mode, the fan operates at a low speed and the compressor starts 2.5~3minutes later. As the compressor starts, the fan speed also resumes its previous setting mode.
1. Dial the number which is connected with the air TURN OFF 2 conditioner. 2. After 3. You 5 times. ringing can hear the Beep Beepsound (if the air ON),then press the numbers "0" accordingly. conditioner is "0" "0" "0" When TroubleshtingpCadMcOISfyP 16 2. OGM using along with ARS "9" telephone provided after signal sound rings four times and then "Beep"(sounds from telephone itself) sounds so that outside recording can be done. 3. Press the numbers "0" "9" "0" "0" "0" accordingly.
Care and maintenance of the air conditioner CAUTION: Before performing any maintenance, turn off the main power to the system. Indoor Unit Never Grille, Case, and Remote Control ? Turn the system off before cleaning. To clean, wipe with a soft, dry cloth. Do not use bleach or use any of the ENGLISH followings: Water hotter than 40°C Could deformation and/or cause discoloration. abrasives.
Replacement of Purifying Filter(Option) ? Recomended 1 Open use period front panel : About 2 years and remove air 2 Remove air 3 Insert purifying filters. filters. new air purifying filters. Air filter TroubleshtingpCadMcOISfyP 18 2 3 4 Reinsert air filters and close front panel. Air purifying filter Outdoor Unit The heat exchanger coils and panel vents of the regularly.
When the air conditioner is not going to be used for a long time. When air conditioner is not used for going to be When the air conditioner is to be used long time. a Clean the air filter and install it in the indoor Operate the air conditioner on Air circulation mode (Refer to page 14) for 2 to 3 hours. unit. (Refer to page ? This will dry 17 for cleaning filters.) out the internal mechanisms. Turn off the circuit the ENGLISH again. breaker, and disconnect plug.
Before you call for service... Troubleshooting Tips! Save ? Check the following points contact your dealer or before CarendMitcOpgIsuoSfyP Troubleshtingp 20 The air conditioner does not operate. ? a service.... If the fault peculiar ? odor. persists, please See page Have you made a mistake in timer operation? Has the fuse blown or has the circuit breaker been has or Explanation ? room requesting repairs money! service center.
