Owner's Manual

5
INTRODUCTION
Indoor Installation-NOTES
R
Do not
place
the
projector
where it
might
be
exposed
to dust.
-
This
may
cause a fire hazard !
When
installing
the
projector
on a
table,
be
careful not to
place
it near the
edge.
-
This
may
cause the
projector
to fall
causing
serious
injury
to a child
or adult and serious
damage
to the
projector.
-
Only
use a
suitable stand.
R
Only
use the
projector
on a level and sta-
ble surface.
-
It
may
become unstable and affect
operation.
R
Ensure
good
ventilation around the
pro-
jector.
The distance between the
projector
and the wall should be more
than 30cm.
-
An
excessive increase
in
its internal
temperature may
cause a fire hazard!
K
K
Do not block the
vents(air intake/exhaust)
of
the
projector
or restrict air-flow
in
any way.
-
This would cause the internal
temperature
to
increase and could cause a fire hazard!
R
Do not
place
the
projector directly
on a
carpet, rug
or
place
where ventilation is
restricted.
-
This would cause its
internal
temperature
to
increase and
might
create a fire hazard !
Air intake
exhaust
pipe
Do not use the
projector
in
a
damp place
such as a bathroom where it is
likely
to
get
wet.
-
This
may
cause a fire or an
electric shock hazard !
R
In
case of
using
a receiver
(VCR, Digital
Set
Top Box),
bend antenna cable
between inside and outside
building
to
prevent
rain from
flowing
in.
-
This
may
cause water
damaged
inside the
projector
and could
give
an electric shock.
Outdoor Installation-WARNING