Owner's Manual

BUS-A
BUS-B
A
B
13
INSTALLING THE INTERNET BRIDGE
ENGLISH
Fixing the internet bridge on the wall
Internet bridge can be installed on a wall.
Connecting RS-485 cable to the internet bridge
You need to connect RS-485 cable to the internet bridge.
1 Connect the end of RS-485 cable connected to BUS-A of PI485 to BUS-A part of the internet
bridge.
2 Connect the end of RS-485 cable connected to BUS-B of PI485 to BUS-B part of the internet
bridge.
3 Arrange the cables into A part or B part.
1 Remove the screws on the left/right side
to open the case of the Internet Bridge.
2 Fix it on the wall using the enclosed
screws on the locations marked in the fol-
lowing figure.
CAUTION
During the use of B part, foreign objects may enter, so close the hole after arranging the
cable.
!