Owner’s Manual

20 INSTALLATION
NOTE
• The hinge lever is only present on some models.
7 With a flat-head screwdriver, carefully pry off
and remove the decorative cover e over the
screw holes on the left side of the refrigerator
housing.
8 Remove the decorative screw f located on
the housing between the freezer and
refrigerator doors. (You will need this hole for
the middle hinge bracket.)
9 Flip the middle hinge bracket g. (The flange
h will now be on top.) Position it on the left
side of the refrigerator and reattach it with
two bolts and a Phillips-head screw.
10 Place the refrigerator door down over the
bottom hinge pin on the bottom hinge
bracket.
11 Place the washer i between the refrigerator
door and the middle hinge bracket and
reattach the middle hinge pin j to the middle
hinge bracket with a 1/4 in. socket wrench.
NOTE
• The bracket has been flipped, but the middle
hinge pin stays in the same orientation with its
hexagonal end facing upward.
12 Insert the decorative screw into the outer hole
on the right side of the housing. Attach the
decorative cover on the right side. Cover is
force-fitted.
Assembling the Reversed Freezer Door
1 Pry off the decorative cover on the top left
side of the refrigerator to uncover the screw
holes.