Owner’s Manual

18
INSTALLATION
the opposite side by turning it
counterclockwise.
NOTE
• The leveler is only present on some models.
3 Move the decorative screws to the holes on the
bottom right side of the housing.
4 Turn the refrigerator door upside down on a
non-scratching surface.
5 Loosen the three screws to remove the bracket
b and the hinge pin sleeve c .
6 Move the bracket to the opposite side of the
door and insert the hinge pin sleeve. Reverse
the hinge lever
d by flipping it over. Place it on
top of the bracket, and tighten both down with
the screw. Then insert the remaining 2 screws
to tighten the bracket to the refrigerator door.
NOTE
• The hinge lever is only present on some models.
7 With a flat-head screwdriver, carefully pry off
and remove the decorative cover
e over the
screw holes on the left side of the refrigerator
housing.
8 Remove the decorative screw f located on the
housing between the freezer and refrigerator
doors. (You will need this hole for the middle
hinge bracket.)