Owner’s Manual

41TROUBLESHOOTING
ENGLISH
Water
Ice has bad taste or
odor.
The interior of the refrigerator needs to be cleaned.
• See the Maintenance section for more information.
The ice storage bin needs to be cleaned.
• Empty and wash the bin (discard old cubes). Make sure that the bin is completely dry
before reinstalling it.
Problem Possible Cause & Solution
Water is dispensing
slowly.
Water filter has been exhausted.
• Replacing the water filter is recommended:
- Approximately every six months.
- When the water filter indicator turns on.
- When the water dispenser output decreases.
- When the ice cubes are smaller than normal.
Reverse osmosis filtration system is used.
• Reverse osmosis filtration systems can reduce the water pressure below the minimum
amount and result in icemaker issues. If the problem persists, it may be necessary to
contact a plumber.
Low house water supply pressure.
• The water pressure must be 20 - 125 psi (138 - 862 kPa) on models with water filter.
Water is not
dispensing.
New installation or water line recently connected.
• Dispense 2.5 gallons of water (flush for approximately 5 minutes) to remove trapped air
and contaminants from the system. Do not dispense the entire 2.5 gallon amount
continuously. Depress and release the dispenser pad for cycles of 30 seconds ON and 60
seconds OFF.
The dispenser panel is locked.
• Press and hold the Lock button for three seconds to unlock the control panel and
dispenser.
The dispenser is not set for water dispensing.
• The dispenser can be set for ice or water. Make certain that the control panel is set for the
proper operation. Press the Water button on the control panel to dispense water.
Refrigerator or freezer doors are not closed properly.
• Water will not dispense if any of the refrigerator doors are left open.
Water filter has been recently removed or replaced.
• After the water filter is replaced, dispense 2.5 gallons of water (flush for approximately five
minutes) to remove trapped air and contaminants from the system. Do not dispense the
entire 2.5 gallon amount continuously. Depress and release the dispenser pad for cycles of
30 seconds ON and 60 seconds OFF.
Tubing connecting refrigerator to house supply valve is kinked.
• The tubing can kink when the refrigerator is moved during installation or cleaning.
Resulting in reduced water flow. Straighten or repair the water supply line and arrange it
to prevent future kinks.
The house water supply is not connected, the valve is not turned on fully, or the valve is
clogged.
• Connect the refrigerator to the water supply and turn the water shutoff valve fully open. If
the problem persists, it may be necessary to contact a plumber.
Problem Possible Cause & Solution