Owner’s Manual
Table Of Contents
- IMPORTANT SAFETY INSTRUCTIONS
 - PRODUCT OVERVIEW
 - INSTALLATION
 - OPERATION
 - SMART FUNCTIONS
 - MAINTENANCE
 - TROUBLESHOOTING
 - LIMITED WARRANTY
 
34 MAINTENANCE
WARNING
• To reduce the risk associated with the ingestion 
of contaminants, do not use with water that is 
microbiologically unsafe or of unknown quality 
without adequate disinfection before or after the 
system.
• Use of unauthorized water filters may result in 
product malfunction, water leakage or water 
quality issues, which will not be covered under 
the product warranty.
CAUTION
• Read and follow Use Instructions before 
installation and use of this system.
• Installation and use MUST comply with all state 
and local plumbing codes.
• Do not install if water pressure exceeds 125 psi 
(862 kPa). If your water pressure exceeds 80 psi, 
you must install a pressure limiting valve. 
Contact a plumber if uncertain how to check 
your water pressure.
• Do not install where water hammer conditions 
may occur. If water hammer conditions exist you 
must install a water hammer arrester. Contact a 
plumbing professional if you are uncertain how 
to check for this condition.
• Do not install on hot water supply lines. The 
maximum operating water temperature of this 
filter system is 100 ℉ (37.8 ℃).
• The disposable filter cartridge MUST be replaced 
every 6 months, at the rated capacity or if a 
noticeable reduction in flow rate occurs.
• To protect it from freezing, remove filter 
cartridge when temperatures are expected to 
drop below 34 ℉ (1 ℃).
• Do not install systems in areas where ambient 
temperatures may go above 110 ℉ (43.3 ℃).
• Where a backflow prevention device is installed 
on a water system, a device for controlling 
pressure due to thermal expansion must be 
installed.
• Ensure all tubing and fittings are secure and free 
from leaks.
Replacing the Water Filter
• Replace the water filter:
-  Approximately every six months.
-  When the indicator turns on.
-  When the water dispenser output decreases.
• To purchase a replacement water filter:
-  Visit your local dealer or distributor
-  Search using "water filter" on lg.com
-  Use replacement cartridge: ADQ72910906
1  To remove the old water filter, turn the filter 
counterclockwise and then pull down and out. 
Make sure to rotate the filter down 
completely before pulling it out of the 
manifold hole.
CAUTION
• Make sure to turn off the household water 
supply.
NOTE
• Replacing the water filter causes a small amount 
of water (around 1 oz. or 25 cc) to drain.
• Wrap a cloth around the front end of the water 
filter cover to collect any leaking water. Hold the 
water filter upright, once it is removed, to 
prevent any remaining water from spilling out of 
the water filter.
2  To replace with a new water filter, remove the 
red cap from the new filter.
NOTE
• The substitute cap must be retained for the 
future. If the filter is removed and not replaced, 
it is necessary to reinstall the substitute cap to 
prevent water leaks from the filter housing.
3  Insert the filter into the filter receptacle on the 
left side of the refrigerator compartment.










