Owner’s Manual

15INSTALLATION
ENGLISH
Reversing Doors and
Leveling
Reversing Doors
This feature is only available on some models.
The method for reversing the door may differ
depending on the model.
The appliance is designed with reversible doors
that can be assembled to open from either the left
or right side to suit your kitchen design.
Door reversal must be done by an authorized
installer or service person. If it is not, any damage
caused by improperly installed doors will not be
covered by the warranty.
WARNING
• Use two or more people to remove and install
the refrigerator doors.
• Disconnect the electrical supply to the
refrigerator before installing.
CAUTION
• Be careful when handling the hinge and hinge
lever.
• Remove food and bins before detaching the
doors.
• Do not hold the handle when removing or
replacing the doors as the handle may come off.
• Tools Needed
- Flat-head screwdriver
- 1/4 in. Hex socket wrench
- 3/8 in. Hex socket wrench
- 1.4 in. Hex key wrench
- Adjustable wrench
Removing the Freezer Door
1 Gently pry off the top hinge cover a with a
flat-head screwdriver and remove it.
2 Use 10 mm or 3/8 inch socket wrench, remove
the three bolts and lift off the top hinge b. Set
parts aside.
3 Lift freezer door slightly and remove it.
4 Turn the freezer door upside down on a non-
scratching surface. Loosen the screw to
remove the hinge lever and hinge pin sleeve.
5 Move the middle hinge bracket to the other
side of the door, keeping the same
orientation.
6 Move the hinge pin sleeve c into the hole on
the left side of the bracket d.