Owner’s Manual

21INSTALLATION
ENGLISH
2 Place the freezer door down over the middle
hinge pin on the middle hinge bracket.
3 Place the top hinge on top of the freezer door
and line up the top hinge with the holes on
top of the refrigerator. Use the three bolts to
attach the hinge.
4 Force-fit the top hinge cover over the top
hinge.
5 Insert the decorative cover on the top right of
the cabinet to cover the holes. Cover is force-
fitted.
NOTE
• After changing doors, make sure that the
corners of the door gaskets are not folded over.
To ensure a good seal, apply a small amount of
silicon grease on the corners a of the gaskets.
Leveling the Refrigerator
The refrigerator has two front leveling legs. Adjust
the legs to alter the tilt from front-to-back or side-
to side. If the refrigerator seems unsteady or the
doors do not close easily, adjust the refrigerator’s
tilt, using the instructions below:
1 Turn the leveling leg to the left to raise that
side of the refrigerator or to the right to lower
it. It may take several turns of the leveling leg
to adjust the tilt of the refrigerator.
NOTE
• A flare nut wrench works best, but an open-end
wrench will suffice. Do not over-tighten.
2 Open both doors, and check to make sure
that they close easily. If the doors do not close
easily, tilt the refrigerator slightly more to the
rear by turning both leveling legs to the left. It
may take several more turns, and be sure to
turn both leveling legs the same amount.