Owner’s Manual

10
EN
Installation Requirements
Remove packing materials from the wall sleeve
and tape from the air conditioner.
• If you use an existing wall sleeve, you should
measure its dimensions.
Install the new air conditioner according to
these installation instructions to achieve the
best performance. All wall sleeves used to
mount the new air conditioner must be in good
structural condition and have a rear grille
to securely attach the new air conditioner.
(Figure 1)
With the LGE sleeve(optionally supplied
with your unit), you can maintain the best
performance of the new air conditioner.
(Figure 2)
After assembly of sleeve and front grille, the
gap should be over 20” from both sleeve and
grille. (Figure 3)
14-
13
/
32
"
(366 mm)
24"(610 mm)
18-
15
/
32
"(468 mm)
20-
3
/
32
"
(511 mm)
Figure 1
AirConditioner
15-
17
/
32
"
(394 mm)
16-
23
/
32
"
(425 mm)
25-
7
/
8
"
(656 mm)
Aluminum metal grille
Figure 2
LGE Wall Sleeve
Figure 3
Over 20"
HEAT
RADIATION
WALL
WALL
INSULATION
SLEEVE
INTAKE
AIR
COOLED
AIR
1/4" Bubble
of the level
Over 20"
Electrical Service
• Check your available electrical service. The
power supply available must be the same as
that shown on the unit nameplate (found on left
side of cabinet).
• All models are equipped with a 3-prong service
plug to provide proper service and safe positive
grounding. Do not change plug in any way. Do
not use an adapter plug. If your present wall
outlet does not match your plug, call a qualified
electrician to make the necessary corrections.
SAVE CARTON for storage and this OWNER’S
MANUAL for future reference. The carton is the
best way to store unit during winter or when not
in use.
Installation Hardware
1
5
6
7
8
3
2 4
9
2 Size options
2 Size options
ITEM NAMEOFPARTS Q'TY
1 1
2 1
1
3 2
4
5 2
6 1
1
7 2
8 2
9
10
PLASTIC NUTSAND WASHER SCREWS
INSULATION STRIP
PLASTIC GRILLE
VERTICALINSULATION STRIP
AROUND INSULATION STRIPS
HORIZONTAL INSULATION STRIP
SUPPORT BLOCK
BAFFLE
TRIM FRAME
SHIM
4
10
CAUTION
To avoid risk of personal injury, property damage,
or product damage due to the weight of this device
and sharp edges that may be exposed:
• Air Conditioners covered in this manual pose
an excessive weight hazard. Two or more
people are needed to move and install the unit.
To prevent injury or strain, use proper lifting
and carrying techniques when moving unit.