Owner's Manual

4
Safety Precautions
Operating Instructions
Care and Maintenance
Troubleshooting Tips
Signal
receptor
Operation
indication
lamps
Preparation
before
operation
Storage
and
Tips
For
Using
the Remote Control
?
The remote control
may
be stored mounted on a
wall.
?
To
operate
the room air
conditioner,
aim the
remote control at the
signal
receptor.
How to Insert the Batteries
Remove the
battery
cover
by
pulling
it
according
to the
arrow direction.
Insert new batteries
making
sure that the
(+)
and
(-)
of
battery
are installed
correctly.
Reattach the cover
by
sliding
it back into
position.
NOTES:
?
Use 2
AAA(1.5volt)
batteries. Do not use
rechargeable
batteries.
Signal Receptor
Receives the
signals
from the remote
control.(Signal receiving
sound: two short
beeps
or one
long
beep.)
Operation
Indication
Lamps
On/Off :
Lights
up
during
the
system operation.
Timer or
Sleep
Mode :
Lights
up
during
Timer
operation
or
Sleep
mode.
Defrost Mode :
Lights
up
during
Defrost Mode or Hot
Start
operation (Heat pump
model
only)
:
Lights
up
during
outdoor unit
operation.
(Cooling
model
only)
Plasma Mode :
Lights
up
during
plasma-purification operation.
(option)
Auto Restart Mode :
Lights
up
during
if Restart Button is
pressed.
Auto Restart Button : In failure of electric
power,
if the button is
pressed
the unit runs as
previous
setting
operation
when
power
returns.
Forced
Operation
Button :
Operation
starts,
when this button is
pressed
and
stops
when
you press
the button
again.
Outdoor unit
operation