Owner’s Manual

28 OPERATION
oven and still believe that the temperature is
hotter or colder than expected, you can manually
calibrate the displayed oven temperature.
There are 2 methods for adjusting the
temperature display.
• Method 1: Try to gauge how much to increase or
decrease the displayed temperature by testing
familiar recipes at higher or lower temperatures
than recommended. This may help you decide
the amount of temperature adjustment you
want.
• Method 2: Adjust the temperature to 15 °F (8 °C)
hotter or cooler at first. Try the oven with this
setting. If you still need to adjust the oven
temperature, use the results of the first
adjustment as a reference and vary the
temperature adjustment amount until the oven
temperature display is calibrated to your
satisfaction.
1 Press Settings a repeatedly until AdJU b
shows in the display.
2 Use the number buttons c to enter the
number of degrees you want to adjust the
oven temperature. The temperature
adjustment is shown next to
AdJU d. You can
adjust the temperature up or down by 35 °F
or 19 °C.
3 To lower the temperature, press Settings a
to add a minus sign (-) to the displayed
number. To raise the temperature, press
Settings a to remove the minus sign in the
display.
4 Press START e to accept the change.
NOTE
• This adjustment does not affect the broiling or
Self Clean temperatures. The adjustment is
retained in memory after a power failure. The
oven temperature can be adjusted by ±35 °F (±19
°C).
• Once the temperature is adjusted, press
Settings repeatedly until AdJU is displayed to
see the amount you adjusted and change it if
needed.
• The temperatures displayed by an oven
thermometer placed in the oven cavity may
differ from the actual set oven temperature in all
modes.
Turning the Preheat Alarm Light On/
Off
When the oven reaches its set-temperature, the
preheating alarm light flashes 5 times or until the
oven door is opened.
You can activate or deactivate the preheating
alarm light.
1 Press Settings repeatedly until PrE appears in
the display.
2 Press 1 repeatedly to select the light on/off.
3 Press START to accept the change.
Adjusting the Beeper Volume
1 Press Settings repeatedly until 8EEP appears
in the display.
2 Press 1 repeatedly to select Hi, Lo or Off.
3 Press START to accept the change.
NOTE
• Adjusting the beeper volume does not affect the
preheat alarm volume.
Selecting Fahrenheit or Celsius
Set the oven temperature display to show either
Fahrenheit (℉) or Celsius (℃) units. The oven
defaults to Fahrenheit unless changed by the user.
1 Press Settings repeatedly until UNit appears
in the display.
2 Press 1 repeatedly to select F (Fahrenheit) or C
(Celsius).