Troubleshooting Guide

67TROUBLESHOOTING
ENGLISH
Areas of
discoloration on the
cooktop
Food spillovers not cleaned before next use.
Hot surface on a model with a light-colored cooktop.
disappear as the glass cools.
Frequent cycling on
and off of surface
units
The element will cycle on and off to maintain the heat setting.
Scratches or
abrasions on
cooktop surface
Coarse particles such as salt or sand between cooktop and utensils can cause
scratches.
utensils are clean before using. Small
scratches do not affect cooking and will become less visible with time.
Cleaning materials not recommended for glass-ceramic cooktop have been used.
Cookware with rough bottom has been used.
Metal marks Scraping of metal utensils on cooktop surface.
ace. Use a glass-ceramic cooktop cleaning
creme to remove the marks. See the "Glass-Ceramic Cooktop" section in the
MAINTENANCE chapter.
Brown streaks or
specks
Boilovers are cooked onto surface.
e "Glass-Ceramic Cooktop" section in the
MAINTENANCE chapter.
Areas of
discoloration on
cooktop
Mineral deposits from water and food.
ng creme. Use cookware with clean, dry
bottoms.
Oven control beeps
and displays any F
code error.
Electronic control has detected a fault condition.
clear the display and stop beeping. Reprogram
oven. If fault recurs, record fault number and contact a Service agent.
Displayed colon in
the clock is flashing
This means that the product has just been plugged in, or that it has experienced a
power interruption.
CLEAN and door
flash in the display
(On some models)
The Self Clean cycle has been selected, but the door is not closed.
Loc is on in the
display when you
want to cook (On
some models)
The oven is locked because of the Control Lock / Lockout feature.
Control Lock / Lockout feature.
Oven light does not
work.
It is time to replace the lamp or the lamp is not tightened enough.
Convection fan
stops. (During
Conv.Bake mode)
Convection fan stops during a convection bake cycle. It is done to allow for more even
heating during the cycle.
Fan operation
(During Bake mode)
This is to ensure even baking results.
throughout a normal bake cycle in the oven.
Problem Possible Cause & Solution