Troubleshooting Guide

66 TROUBLESHOOTING
Parts & Features
Excessive smoking
during a Self Clean
cycle (On some
models)
Excessive soil.
Self Clean mode is cancelled. Wipe up the excess soil and reset the clean.
Burning or oily odor
emitting from the
vent
This is normal in a new oven.
hours. See the Self Clean section. (On some models)
Moisture collects on
oven window or
steam comes from
oven vent
This happens when cooking foods high in moisture.
Excessive moisture was used when cleaning the window.
Problem Possible Cause & Solution
Range is not level. Poor installation.
vel on the oven rack. Adjust leveling legs at
base of range until the oven rack is level.
able enough to adequately support range.
t a carpenter to correct the situation.
Kitchen cabinet alignment may make range appear unlevel.
sufficient room for range clearance.
Cannot move
appliance easily.
Appliance must be
accessible for
service.
Cabinets not square or are built in too tightly.
to make appliance accessible.
Carpet interferes with range.
Anti-tip device engaged.
to move the range. Reengage the anti-tip device after pulling
the range out for cleaning, service, or any other reason.
Surface units will not
maintain a rolling
boil or cooking is not
fast enough.
Improper cookware being used.
In some areas, the power(voltage) may be low.
Surface units do not
work properly.
A fuse in your home may be blown or the circuit breaker tripped.
Cooktop controls improperly set.
set for the surface unit you are using.
Surface unit stops
glowing when
changed to a lower
setting.
The unit is still on and hot.
Problem Possible Cause & Solution