Owner's Manual

18
In such a case, remove the original plug and using a
soldering iron, connect a lens iris plug according to
the diagram. (Refer to next page.)
lens iris output connector
Pin layout for the lens iris output connector.
No. DC type lenses VIDEO type lenses
1 Damping - Vcc (+9 V)
2 Damping + Not used
3 Drive + Video
4 Drive - Ground
Rewire the lens iris plug
1. Cut off the plug of the lens cable, cut off
approximately 8mm of the insulation, and then
strip approximately 2mm of the ends of the cable
sheaths.
8mm
2mm
2. Solder the ends of the cable wires to the ends of
the pins, and then attach the cover of the lens iris
plug.
Connections