Owner’s Manual
Table Of Contents
10 INSTALLATION
Dimensions and Clearances
• Check the dimensions of the appliance and the installation path to ensure there is sufficient room to
move the refrigerator through doors or narrow openings.
• If an opening is too narrow to fit the refrigerator through, remove the refrigerator doors. See Removing/
Assembling Doors and Drawers in this manual.
• The installation location chosen for the refrigerator should allow space behind the unit for connections
and airflow and space in front to open the doors and drawers.
• Too small of a distance from adjacent items may result in lowered freezing capability and increased
electricity consumption charges. Allow at least 2 inches (50 mm) between the back of the refrigerator
and the wall.
• Remember to allow enough room in front of the refrigerator to fully open the doors.
Leveling
Leveling the Refrigerator
The refrigerator has two front leveling legs. Adjust
the legs to alter the tilt from front-to-back or side-
to side. If the refrigerator seems unsteady or the
doors do not close easily, adjust the refrigerator’s
tilt, using the instructions below:
1 Turn the leveling leg to the left to raise that
side of the refrigerator or to the right to lower
it. It may take several turns of the leveling leg
to adjust the tilt of the refrigerator.
NOTE
• A flare nut wrench works best, but an open-end
wrench will suffice. Do not over-tighten.
- Dimensions/Clearances LRONC0705* LRONC0605*
A Depth without Handle 21 7/8" (555 mm) 21 7/8" (555 mm)
B Width 20 5/8" (525 mm) 20 5/8" (525 mm)
C Height to Top of Case 50 7/8" (1292 mm) 44 5/8" (1132 mm)
D Height to Top of Hinge 51" (1295 mm) 44 5/8" (1135 mm)
E Back Clearance 2" (50 mm) 2" (50 mm)
F Depth without Door 18 5/8" (473 mm) 18 5/8" (473 mm)
G Depth (Total with Door Open 90°) 39 5/8" (1008 mm) 39 5/8" (1008 mm)
G
A
B
C
D
E
F