Installation Manual

PREPARE TO INSTALL THE RANGE

INSTALLATION DRAWINGS

SAVE FOR THE USE OF THE LOCAL ELECTRICAL INSPECTOR

NOTE

CLEARANCES AND DIMENSIONS (Figure 1)

To install range refer to the following Figure 1.

For installation in CANADA, a Free-standing range

is not to be installed closer than 15/32 (12mm) from

any adjacent surface.

• Cabinet storage space located above the

surface units should be avoided.

• Install a range hood that projects horizontally a

minimum of 5 inches beyond the bottom of the

cabinets if cabinet storage is to be provided.

- The risk of burns or fire by reaching over the

heated surface elements can be reduced.

• Make sure that the wall covering, countertop

and cabinets around the range can with-stand

the heat (up to 194°F) generated by the range.

Discoloration, delamination or melting may occur.

- This range has been designed to comply with

the maximum allowable wood cabinet tem-

peratures of 194°F.

CAUTION

FIGURE 1 FIGURE 2

A = 30”(76.2 cm) For U.S.A

= 30”(76.2 cm) ~ 31”(78.7 cm) For CANADA

• You should use two or more people to move and

install range. (Excessive Weight Hazard)

- Failure to do so can result in back or other injury.

• You never pull or push any handles of upper &

lower door to move and install range.

- Failure to do so can result in serious damage to

the door of the range.

WARNING

For model : LRE Series