Owner’s Manual

18 INSTALLATION
3 Lift the door from the middle hinge pin and
remove the door.
CAUTION
• Place the door, inside facing up, on a non-
scratching surface.
4 Remove the four screws a, the hinge pin
sleeve b, the hinge lever c and hinge
bracket d from the bottom right side of the
door.
5 Turn the hinge lever a over and install it, the
hinge bracket
b, screws c, and hinge pin
sleeve d on the bottom left side of the door.
6 Use a 1/4 in. (6.35 mm) hex socket wrench to
loosen the hinge pin a and remove it. Use a
3/16 in. (5 mm) Allen wrench and a Phillips
screwdriver to remove the two Allen-head b
and one Phillips-head c screws. Remove the
hinge
d.
7 With a flat-head screwdriver, carefully pry off
and remove the cover over the bolt holes on
the left side of the refrigerator.
8 Remove the outer lower decorative screw
from the flange on the frame between the
freezer and refrigerator doors. (You will need
this hole for the middle hinge.)
9 Flip the middle hinge bracket and position it
on the left side of refrigerator. Insert two
Allen-head screws and the Phillips-head
screw.
10 Insert middle hinge pin using a 1/4 in. (6.35
mm) socket wrench.
us_main.book.book Page 18 Monday, March 2, 2020 3:48 PM