User guide
Please read this manual carefully before operating 
your set and retain it for future reference. 
MODEL
LNB5110 series
OWNER’S MANUAL
High 
Denition 
Network 
Camera
Warning: Do not install this equipment in a 
confined space such as a bookcase or similar 
unit.
Warning: Wiring methods shall be in 
accordance with the National Electric Code, 
ANSI/NFPA 70.
Warning: This is a class A product. In a 
domestic environment this product may cause 
radio interference in which case the user may 
be required to take adequate measures.
Warning: To reduce a risk of fire or electric 
shock, do not expose this product to rain or 
moisture.
Warning: Please adopt the power adapter 
which can meet the safety extra low voltage 
(SELV) standard. And source with DC 12 V or  
AC 24 V (depending on models) according 
to the IEC60950-1 and Limited Power Source 
standard.
Warning: Install the camera on a ceiling or wall 
where can withstand the weight of 5 times of 
the camera including mounting bracket.
Caution: This installation should be made by a 
qualified service person and should conform to 
all local codes.
Caution: To avoid electrical shock, do not 
open the cabinet. Refer servicing to qualified 
personnel only.
Caution: The apparatus shall not be exposed 
to water (dripping or splashing) and no objects 
filled with liquids, such as vases, shall be placed 
on the apparatus.
Caution: Make sure the power supply voltage 
is correct before using the camera.
Caution: Do not drop the camera or subject it 
to physical shock.
Caution: The sensor may be burned out by 
a laser beam, so when any laser equipment is 
being used, make sure that the surface of the 
sensor not be exposed to the laser beam.
Caution: While shipping, the camera should be 
packed in its original packing.
To disconnect power from mains, pull 
out the mains cord plug. When installing 
the product, ensure that the plug is easily 
accessible.
LG Electronics hereby declares 
that this/these product(s) is/
are in compliance with the 
essential requirements and 
other relevant provisions of 
Directive 2004/108/EC and 
2011/65/EU. 
Contact office for compliance of this 
product:
LG Electronics Inc. 
EU Representative, Krijgsman 1,1186 DM 
Amstelveen, The Netherlands
• Please note that this is NOT a Customer 
Service contact point. For Customer 
Service Information, see Warranty Card 
or contact the dealer that you purchased 
this product.
CAUTION
RISK OF ELECTRIC SHOCK  
DO NOT OPEN
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK
DO NOT REMOVE COVER (OR BACK)
NO USER-SERVICEABLE PARTS INSIDE
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
This lightning flash with arrowhead symbol within an equilateral triangle is 
intended to alert the user to the presence of uninsulated dangerous voltage 
within the product’s enclosure that may be of sufficient magnitude to 
constitute a risk of electric shock to persons. 
The exclamation point within an equilateral triangle is intended to alert the 
user to the presence of important operating and maintenance (servicing) 
instructions in the literature accompanying the product.
FCC WARNING: This equipment may generate or use radio frequency energy. Changes or 
modifications to this equipment may cause harmful interference unless the modifications are 
expressly approved in the instruction manual. The user could lose the authority to operate this 
equipment if an unauthorized change or modification is made.
REGULATORY INFORMATION: FCC Part 15
This equipment has been tested and found to comply with the limits for a Class A digital device, 
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection 
against harmful interference when the equipment is operated in a commercial environment. 
This equipment generates, uses, and can radiate radio frequency energy and, if not installed 
and used in accordance with the instruction manual, may cause harmful interference to radio 
communications. 
Operation of this equipment in a residential area is likely to cause harmful interference in which 
case the user will be required to correct the interference at his own expense.
• A suitable conduit entries, knock-outs or glands shall be provided in the cable entries of this 
product in the end user.
• Caution: Danger of explosion if battery is incorrectly replaced. Replaced only with the same or 
equivalent type recommended by the manufacturer. Dispose of used batteries according to 
the manufacturer’s instructions.
• Holes in metal, through which insulated wires pass, shall have smooth well rounded surfaces 
or shall be provided with brushings.
This Class A digital apparatus complies with Canadian ICES-003. 
Cet appareil numérique de la classe A est conforme à la norme NMB-003 du Canada.
Important Safety 
Instructions
1.  Read these instructions. 
2.  Keep these instructions. 
3.  Heed all warnings. 
4.  Follow all instructions. 
5.  Do not use this apparatus near water.
6.  Clean only with dry cloth.
7.  Do not block any ventilation openings. 
Install in accordance with the 
manufacturer’s instructions. 
8.  Do not install near any heat sources such 
as radiators, heat registers, stoves, or other 
apparatus (including amplifiers) that 
produce heat. 
9.  Do not defeat the safety purpose of the 
polarized or grounding-type plug. A 
polarized plug has two blades with one 
wider than the other. A grounding type 
plug has two blades and a third grounding 
prong. The wide blade or the third 
prong are provided for your safety. If the 
provided plug does not fit into your outlet, 
consult an electrician for replacement of 
the obsolete outlet.
10.  Protect the power cord from being 
walked on or pinched particularly at plugs, 
convenience receptacles, and the point 
where they exit from the apparatus.
11.  Only use attachments/accessories 
specified by the manufacturer.
12.  Use only with the cart, stand, tripod, 
bracket, or table specified by the 
manufacturer, or sold with the apparatus. 
When a cart is used, use caution when 
moving the cart/apparatus combination 
to avoid injury from tip-over.
13.  Unplug this apparatus during lightning 
storms or when unused for long periods 
of time.
14.  Refer all servicing to qualified service 
personnel. Servicing is required when 
the apparatus has been damaged in any 
way, such as power-supply cord or plug 
is damaged, liquid has been spilled or 
objects have fallen into the apparatus, the 
apparatus has been exposed to rain or 
moisture, does not operate normally, or 
has been dropped.
Handling of the unit
Be careful not to spill water or other liquids on 
the unit. Be cautious not to get combustible or 
metallic material inside the body. If used with 
foreign matter inside, the camera is liable to fail 
or to get cause of fire or electric shock.
• Remove dust or dirt on the surface of the 
lens with a blower.
• Use a soft and lint-free, dry cloth(such as 
glass cleaner) to clean the body. If it is 
very dirty, use a cloth dampened with a 
small quantity of neutral detergent then 
wipe dry.
• Avoid the use of volatile solvents such 
as thinners, alcohol, benzene and 
insecticides. 
They may damage the surface finish and/
or impair the operation of the camera.
• This camera is designed for mounting on 
the ceiling or wall. If you install this camera 
upside down, it may cause malfunction.
Operating and storage 
location
Avoid viewing a very bright object (such as 
light fittings) during an extended period. Avoid 
operating or storing the unit in the following 
locations.
• Extremely hot or cold places (operating 
temperature -10 °C to 55 °C, however, we 
recommend that the unit be used within a 
temperature range of 0 °C to 45 °C)
• Damp or dust place
• Places exposed to rain
• Places subject to strong vibration
• Close to generators of powerful 
electromagnetic radiation such as radio or 
TV transmitters.
• Do not use the camera in such place 
where rapid temperature fluctuation by 
switching an air conditioner on and off.
Specication 
Item LNB5110 series
Camera
Image Device 6.28 mm (1/3 Type) CMOS 
Lens Type CS mountable
Day/Night ICR (Auto / Day / Night / External / Schedule)
Minimum Illumination
Color: 0.03 lx (F1.2, Gain : High, 1/30 sec, 50 IRE)
B/W: 0.002 lx (F1.2, Gain : High, 1/30 sec, 50 IRE)
WDR Support
Image Enhancement 
Backlight Compensation, 2D+3D-DNR, De-fog, 
Exposure Control, AGC, White Balance, Privacy Masking, 
Sharpness, EIS, Pivot
Video / 
Audio
Compression  H.264, H.264_High, MJPEG
Resolution
1280 x 1024 / 1280 x 720 / D1 (704 x 576) / 
CIF (352 x 240)
Maximum Frame Rate 60 fps @ 1280 x 1024
Multi-Streaming Up to 4
ROI (Region of Interest) Smart codec (Up to 8)
Video Analytics
Motion detection, Tampering alarm, Face detection, 
Intrusion detection, Crossing line, Object counting, 
Object removal, Object desertion
Text Overlay Support
Audio Compression G.711, G.726
2-way Audio  Support
Audio Detection Support
Event
Event Trigger Video analytics, Audio detection, Alarm input
Event Notication Relay Out, Email, FTP
Pre Event Buering Support
Interface
Analog Out RCA out 
Audio In/Out  1 / 1
Alarm In/Out 1 In / 1 Out
RS-485 Support
SD Slot micro SD (Up to 32 GB)
Network
Ethernet RJ-45 10/100BASE-T
Security 
Password protection, HTTPS (SSL, TLS), IP ltering, 
IEEE 802.1X
Open Protocol ONVIF 2.2 Prole S, PSIA 1.1
Protocol
IPv4 and IPv6 : TCP/IP, UDP, HTTP, HTTPS, RTP, RTSP, 
DHCP, ICMP, QoS, UPnP
IPv4 : FTP, SMTP, NTP, ARP, SNMP v1/v2c/v3, DDNS(LG)
Integrated Software
LG Ipsolute VMS Suite / Mobile application (iPhone, 
iPad, Android)
Connections Up to 20
General
Power Source DC 12 V, PoE
Maximum Power 
Consumption
5.9 W
Maximum Input Current 490 mA (DC 12 V), 130 mA (PoE)
Operation Temperature/
Humidity
-10 ºC to 55 ºC / 0 % RH to 80 % RH
Dimension (W x H x D) 69 mm x 54 mm x 122 mm
Weight  365 g
Component
Camera, CD (Software and Owner’s Manual), Installation Manual


