Owner's Manual

18 INSTALLATION
2 Grasp the drawer on each side and hook the
drawer supports into the rail tabs located on
both sides.
CAUTION
• Do not hold the handle when removing or
replacing the drawer. The handle may come off,
causing personal injury.
3 Lower the door into its final position and
insert the screws in the rails on both sides.
4 Insert the basket into the frame, and push the
drawer back until it clicks into place.
Connecting the Water Line
Before Beginning
This water line installation is not covered by the
refrigerator warranty. Follow these instructions
carefully to minimize the risk of expensive water
damage.
If necessary, call a qualified plumber to correct
water hammer before installing the water supply
line to the refrigerator. Water banging in the
pipes, or water hammer in residential plumbing
can cause damage to refrigerator parts and lead to
water leakage or flooding.
• Turn the icemaker OFF if the refrigerator will be
used before the water line is connected.
• Do not install the icemaker tubing in areas
where the ambient temperatures fall below
freezing.
WARNING
• Connect to potable water supply only.
CAUTION
• To prevent burns and product damage, only
connect the refrigerator water line to a cold
water supply.
CAUTION
• Wear eye protection during installation to
prevent injury.
Water Pressure
You will need a cold water supply.
If the water pressure from the reverse osmosis
system is less than 20 psi or 138 kPa or 1.4 kgf/
cm
2
(takes more than 4 seconds to fill a cup of 7 oz
or 198 cc capacity):
Water Pressure
models with water filter 20 - 120 psi (138 - 827
kPa)
where reverse osmosis
water filtration system
is connected to a cold
water supply
40 - 60 psi minimum to
reverse osmosis system
(2.8 kgf/cm
2
- 4.2 kgf/
cm
2
, or less than 2 - 3
seconds to fill a cup of 7
oz capacity)