Installation Manual

22 Multi Air Conditioner

Installation

Installation of Wired Remote Controller(Optional)

1. Properly secure the mounting plate in a preferred location using provided screws.

- Avoid bending the mounting plate by not over-tightening the provided screws.

Please set up remote controller board fit to the reclamation box if there is a reclamation box.

- Ensure that the mounting plate and controller are securely attached to the wall to prevent shaking after

the installation.

2. Can set up Wired remote controller cable into three directions.

- Setup direction: the surface of wall reclamation, upper, right

- If setting up remote controller cable into upper and right side, please set up after removing remote

controller cable guide groove.

Remove guide groove with long nose.

①

Reclamation to the surface of the wall

②

Upper part guide groove

③

Right part guide groove