Installation Guide

09
•
•
When installing modules in heavy snow areas,
it is recommended to be taken an appropriate
countermeasure to prevent possible damages to the
lower side frame by slipping snow.
We recommend to use corrosion resistant material
according to standard UL 1703 or UL2703 for these
supporting part. (A snow guard should be installed in
accordance with the manufacturer’s instructions.)
Solar module
Roof
Supporting part
Mounting by using frame bolts holes
•
Secure the solar module to the structure by using the
factory mounting holes.
•
Four M8(5/16inch) stainless steel bolts, four nuts,
recommended per solar module.
•
The module may be fastened to a support by using
both the outer and inner bolt holes of the frame.
•
Each module should be securely fastened at a
minimum 4 points on two opposite sides.
•
and location of mounting holes is provided in ‘Product
•
Tighten the bolt securely by using the combination
shown above. Place the spring washer between the
Flat washer and Nut.
Bolt
Flat washer
Flat washer
Nut
Support
Module frame
Spring washer