Owner's Manual

32
Installation
3
Installation
• PTZ Test: After the PTZ setting, you can test the pan/tilt function
for the selected PTZ camera. You can see the test screen from
the preview windows on the right side of the PTZ test option.
-
b / B
: Test the pan direction.
-
v / V
: Test the tilt direction.
NOTE
The supported PTZ camera list is on page 70 for reference.
IP Camera
• Channel: Selects the desired channel to set the connected IP
camera.
• Vendor: Selects the IP camera vendor from the drop-down list.
• Model Name: Enter the model name of the IP camera.
• Host Name: Enter the IP address of the IP camera.
• User Name: Enter the user ID.
• Password: Enter the user password.
• Port: Enter the port number.
• Test: Select [Test] to test the connection with the IP camera.
NOTE
The Supported IP camera specications.
Specication Description
Vendor LG, AXIS
Recording mode Continuous, Instant
Video Codec H.264 Baseline Prole
Audio recording and playback Not support
Resolution CIF, Half D1(2CIF), D1(4CIF)
Stream Master-0 only for LG camera
PTZ Not support
Sensor/Motion input Not support
ATM/POS
• Interface Device: Select the interface device from the drop-
down list.
- NONE: Selects when the ATM/POS device is connected with
the DVR directly.
- AVE Hydra: Selects when the ATM/POS device is connected
via the AVE Hydra device to the DVR. If you set to AVE Hydra,
the [Camera], [Baud Rate], [Data Bits], [Stop Bits] and [Parity]
options are dimmed and these options are not set.
• Camera: Select the camera number for mapping with ATM/POS
device.
• Baud Rate: Select the desired parameter to set the
communication speed between DVR and ATM/POS device.
• Data Bits: Select the number of the data bits for RS-485
communication.
• Stop Bits: Select the desired parameter. The stop bit, added to
the last of data, in asynchronous communication.
• Parity: Select the desired parameter. The parity bit, added to the
data, to perform parity check.