Owner's Manual

Installation
31
3
Installation
NOTE
• The disc burning is carried out by a single session closed
format.
• If you use the CD/DVD writer device for backup, it is making
ISO image and then writing the backup data to the CD/DVD.
• You can see the backup progress status on the system control
bar.
• The estimated size of backup data is only the approximate size.
So you must prepare sucient space on the media to prevent
lack of space.
• At the scheduled recording time, you can check the backup
status on the system control bar.
• While export is in progress or searching the backup data
from the external USB device, the scheduled backup will
not be started. After the export or backup search is nished,
scheduled backup will be restarted.
• When you set the schedule backup, the backup data size is
estimated from the recording settings of the Setup menu. If
the real recorded data size is over the estimated recording
data size, the schedule backup may not be activated.
Device settings
Camera
• Ch: Displays the channel number.
• Name: Enter the channel name using up to 20 characters.
• Audio: Select the input audio channel. You can hear from the
selected input audio channel. This function is not available for IP
channels.
PTZ
Settings for the PTZ cameras connected via the data port of the
RS-485 terminal.
• Channel: Selects the desired channel to set the connected PTZ
camera.
• Port: Selects the connected data port of the RS-485 terminal
on the rear panel. The DATA 2 port is used to control the PTZ
camera connected to DVR or to control by using the LKD1000
controller. If you want to use the PTZ camera via DATA 2 port,
you should set the [Remote Controller ID] to [NONE]. If you use
the LKD1000 controller to control the DVR via DATA 2 port, you
should set the [Remote Controller ID] number between 1 to 16.
• Control ID: Selects the PTZ camera ID. Make the same settings
as the PTZ camera.
• Protocol: Selects the protocol supported by PTZ camera.
• Baud Rate: Selects the communication speed.