Owner's Manual

68
Symptoms Resolutions
An E-mail sent
from this prod-
uct was not
received.
E-mail reception failed without SMTP server setting.
•
Make sure the network is correctly set.
• Make sure the mail address is input correctly.
• Check the spam mail setting of the inputted mail address.
(If you set the spam mail, some mails are deleted automatically or classified in
the spam mail box)
•
Some of SMTP mail services do not support an E-mails from private SMTP
servers. In this case use the public SMTP server.
E-mail reception failed even if the SMTP server was set.
•
When the [Please check the SMTP information or internet cable] message is
displayed.
-
Check the SMTP server address.
- Check the SMTP port number. (Default setting is 25).
- Check the network settings.
• When the [Please check the authentication information] message is displayed.
- Check the user name.
- Check the password.
• The mail reception failed without error message.
- Check the receiver’s mail address.
- Check your E-mail is not classified as a spam mail on the receiver's mail set-
ting.
The remote
control does not
work properly.
Check the batteries in the remote control.
Check the ID setting for the remote control (See page 40).
Note:
If you observe any of the following symptoms:
• Some of the front panel LEDs do not light.
•
The DVR does not operate normally.
You can reboot the DVR as follows:
•
Turn off the DVR and turn it on again after a few seconds.
When the recorder does not work normally after rebooting, contact the service center.