Owner's Manual

Connections and settings 35
System Settings
Date/Time
Date: Enter the current date.
Time: Enter the current time. (24 HR or 12 HR)
Date Format: Select the date display format.
Time Format: Select the time display format.
Time Zone: Select your Time Zone.
(For more details refer to Timezone table on page 64)
Daylight Saving: Set to ON to you use the daylight sav-
ing function.
Daylight Saving Start: Select the Daylight Saving start
time.
•
•
•
•
•
•
•
Daylight Saving End: Select the Daylight Saving end
time.
Caution:
If you change the time setup, warning message will be dis-
played. For example, if you delay the time by 10 minutes,
the overlapped 10minutes data can be deleted.
NTP
NTP: Set to ON when using the NTP (Network Time
Protocol) server for time adjustment. If the NTP is set to
OFF, the time settings should be entered manually and
the [Server], [Private Time Server], [Sync. Interval] and
[NTP Test] options are not set.
Server: Select your time server. For most cases select
public. The DVR will obtain the average time among 5
public servers (time.nist.gov, time-a.nist.gov, time-b.nist.
gov, ntp.nasa.gov, clock.isc.org).
Private Time Server: Enter the private time server's IP
address or host name using the virtual keyboard.
Sync. Interval: You can set synchronized intervals with
the NTP time server to 1 day, 1 hour, 1 month and 1
week.
NTP Test: Select [NTP Test] to test the NTP server.
Note:
If the NTP option is not set to this system, there can be a
gap between the system time and actual time. Using NTP is
recommended.
•
•
•
•
•
•