Owner's Manual

37OPERATION
ENGLISH
Adding Rinse Aid to the Dispenser
The Rinse Aid indicator appears in the display when
more rinse aid is needed.
The use of rinse aid is recommended to prevent
water spots on dishes and to enhance drying
performance.
1
Opentherinseaidlidbyliftinguptheap.
2
Addaliquidrinseaidtothemaximumlllevel.
The rinse aid should be settled in the dispenser
whilelling,orairbubblesmayresultinpoor
dryingperformance.Avoidoverllingthe
dispenser.
3
Close the lid to lock the dispenser. Rinse aid is
dispensedautomaticallyduringthenalrinse
cycle.
NOTE
• Only use liquid rinse aid in the dishwasher.
• Donotoverlltherinseaiddispenser.
• Wipe off any spilled rinse aid around the dispenser.
Rinse Aid Dispenser Adjustment
Thedispenserhasveadjustmentlevels.The
dishwasher is programmed at the factory for a rinse
aid dispenser level of 2. This can be checked and
altered by using the buttons on the control panel.
1
Ensure the appliance is off.
2
Press Dual Zone and Power simultaneously to
check the current setting.
3
Press Delay Start to change the rinse aid
dispenser setting. Each press of the button
changes the setting one step from L0 to L4.
4
Once the desired rinse aid dispenser setting is
selected, press Start to save.
NOTE
• Adjust the setting higher if you have hard water and
notice calcium buildup on your dishes.
• Setting the rinse aid control too low will contribute
to spotting and streaking on dishes and poor drying
performance.
• Setting the control too high can cause foaming,
which will cause poor wash performance.
Relling the Rinse Aid
Howoftenthedispenserneedstoberelleddepends
on how often dishes are washed and the rinse aid
setting used.
• The Rinse Aid
iconasheswhenmorerinseaid
is needed, unless the rinse aid dispenser setting is
set to L0.