Owner’s Manual

38 OPERATION
NOTE
• Only use liquid rinse aid in the dishwasher.
• Do not overfill the rinse aid dispenser.
• Wipe off any spilled rinse aid around the
dispenser.
1 Open the rinse aid lid by lifting up the flap.
2 Add a liquid rinse aid to the maximum fill
level. Allow the rinse aid to settle in the
dispenser while filling, or air bubbles may
result in poor drying performance. Avoid
overfilling the dispenser.
3 Close the lid to lock the dispenser. Rinse aid is
dispensed automatically during the final rinse
cycle.
Rinse Aid Dispenser Adjustment
The dispenser has five adjustment levels. The
dishwasher is programmed at the factory for a
rinse aid dispenser level of 2. This can be checked
and adjusted from the control panel.
NOTE
• Adjust the setting higher if you have hard water
and notice calcium buildup on your dishes.
• Setting the rinse aid control too low will
contribute to spotting and streaking on dishes
and poor drying performance.
• Setting the control too high can cause foaming,
which will cause poor wash performance.
1 Ensure the appliance is off.
2 Press Dual Zone and Power simultaneously
to check the current setting.
3 Press Delay Start to change the rinse aid
dispenser setting. Each press of the button
changes the setting one step from L0 to L4.
4 Once the desired rinse aid dispenser setting is
selected, press Start to save.
Refilling the Rinse Aid
How often the dispenser needs to be refilled
depends on how often dishes are washed and the
rinse aid setting used.
•The Rinse Aid
e icon flashes when more rinse
aid is needed, unless the rinse aid dispenser
setting is set to L0.