Owner’s Manual
Table Of Contents
- IMPORTANT SAFETY INSTRUCTIONS
- PRODUCT OVERVIEW
- INSTALLATION
- OPERATION
- SMART FUNCTIONS
- MAINTENANCE
- TROUBLESHOOTING
- LIMITED WARRANTY
12 INSTALLATION
• To ensure proper drainage, install the 
dishwasher no more than 12 ft. (3.65 m) from 
the sink.
• The location must have sufficient space for the 
dishwasher door to open easily and provide at 
least 0.1” (2 mm) between the dishwasher and 
the cabinet sides.
• If installing the dishwasher in a corner, leave a 
minimum of 2” (50 mm) between the dishwasher 
and the adjacent wall.
• The adjacent wall must be free of obstructions.
• For flush installations only, you may remove the 
cabinet brace 
a inside the cabinet.
Choosing the Proper Location
1  Select a location as close to the sink as 
possible for easy connections to water supply 
line, drain hose and electrical connection.
2  To allow for proper clearance of plumbing 
and electrical, use the template included with 
the literature to determine the clearance on 
the side of the cabinet where the cabinet 
meets the back wall. Using a 2 1/2” diameter 
hole saw, drill a hole in the target area as 
shown on the template.
WARNING
• Installation damage is not covered by the 
warranty, and leaks caused by improper 
installation may result in property damage.
• Do not use existing holes unless they are in the 
target area.
• Failure to properly locate the hole for the water 
and drain lines may prevent the dishwasher 
from installing flush with the cabinets and could 
result in kinked, pinched, crushed, stressed or 
damaged lines.
Preparing Water and 
Electrical Connections
WARNING
• Water Connection
-  Do not reuse an old hose. Use only a new hose 
when installing the dishwasher. The old hose 
could leak or burst causing flooding and 
property damage. Contact an LG Customer 
Information Center for assistance in buying a 
new hose.
• Electrical Connection
-  Use a time-delay fuse or circuit breaker.
- Operate this appliance with the correct voltage 
as shown in this manual and on the rating 
plate.
-  The wiring must be grounded properly. If in 
doubt, have it checked by a qualified 
electrician.
-  Connect the appliance using 3-wires, including 
a ground wire.
-  The appliance and outlet must be positioned 
so that the plug is easily accessible.
-  Do not use an extension cable or adapter with 
this dishwasher.
-  Do not overload the outlet with more than one 
appliance.
-  The included 16AWG wire nuts should be used.
3.5
 ''
2.5
 ''
4
 ''










