OWNER'S MANUAL Color Video Camera Please read this manual carefully before operating your set and retain it for future reference. MODEL LD120P LD120N P/NO : MFL62723790 D120P-C1.COMMON_MFL62723790_ENG1 1 2010.6.
CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT REMOVE COVER (OR BACK) NO USER-SERVICEABLE PARTS INSIDE REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. This lightning flash with arrowhead symbol within an equilateral triangle is intended to alert the user to the presence of uninsulated dangerous voltage within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.
Caution: To avoid electrical shock, do not open the cabinet. Refer servicing to qualified personnel only. Caution: The apparatus shall not be exposed to water (dripping or splashing) and no objects filled with liquids, such as vases, shall be placed on the apparatus. To disconnect power from mains, pull out the mains cord plug. When installing the product, ensure that the plug is easily accessible. Disposal of your old appliance 1. 2. 3. 4.
Important Safety Instructions 1. 2. 3. 4. 5. 6. 7. Read these instructions. Keep these instructions. Heed all warnings. Follow all instructions. Do not use this apparatus near water. Clean only with dry cloth. Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions. 8. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. 9.
Safety Precautions Do not attempt to disassemble the camera Avoid the camera with direct sunlight Do not use strong solvents or detergents Handle the camera with care To prevent electric shock, do not remove screws or covers. There are no user serviceable parts inside. Ask a qualified service personnel for servicing. Use a dry cloth to the camera when it is dirty. If it is hard to remove the dirt on the camera, use a mild detergent and wipe it gently.
What's in the box Video Cable Camera Body M3 Tapping Screws (2 EA) (Pan Lock Screw) D120P-C1.COMMON_MFL62723790_ENG6 6 2010.6.
Construction Front View Tilt Base Side View D120P-C1.COMMON_MFL62723790_ENG7 7 Tilting Lock Screw Lens Dome Cover 2010.6.
Installation Camera Installation 1 Installation Label 2 Dome cover 3 Lens cover 4~6 Hole for Fixing Tilting Lock Screw (B) M3 Tapping Screw (A) Pan lock Screw (C) 1. Use the installation label to check the place that you wish to install. 2. Turn the Dome Cover counterclockwise simultaneously. 3. Remove the Lens cover. 4. Aim the LG logo of the Dome Camera to face the place that you wish to watch. 5. Tighten the M3 Tapping Screws(A) to fix the Dome Camera on the ceiling. 6.
Installation Camera Connection Connect the Power Adapter (12 V, 300 mA; optional) to the Power Input Jack of the camera as shown below. Cautions for Safe Operation This camera must be operated a DC 12 V Certified/listed, class 2 power supply. D120P-C1.COMMON_MFL62723790_ENG9 9 Power Input Jack Power Adapter (Not supplied) Adapter Jack BNC Monitor 2010.6.
Setup 4-pin Dip Switch Setting This camera has the 4-pin Dip Switch for setting. 1. AGC (Auto Gain Control) - ON : If the image is too dark, increase the AGC value to make the image bright. - OFF : Not used. 2. BLC (Back Light Compensation) - ON : Sets to this position when strong light comes in behind the target. - OFF : Normal position. 3. HSBLC 1 2 3 4 ON - ON : Use for masking brightness of the specific area to view the subject more clearly. - OFF : Not used. ON 1 2 3 4 ON OFF 4.
Troubleshooting Check the following guide for the possible cause of a problem before contacting service. The picture is poor Does the Dome Cover have lots of dust on the surface? - Use a dry cloth to clean the camera when it is dirty. Smear may be caused to the screen of night than daytime. - Adjust the Focus by moving the Focus Lens. Contrast of the screen is not clear. Check the condition of the monitor. A light source such as a spot light causes burn-in on the display screen.
Specifications Model Signal System Total / Effective Pixels Pick-Up Device Lens Day / Night Scanning System Scanning Frequency Resolution S/N Ratio Minimum Illuminance Video Output Signal Shutter Speed Dip switch Power Source Power Consumption Operating Temp. Storage Temp. Weight Dimensions LD120N LD120P NTSC PAL 410 000 Pixel / 470 000 Pixel / 380 000 Pixel 440 000 Pixel 6 mm Super Had CCD II 3.6 mm(C1) / 2.5 mm(A1) Auto 2 : 1 Interlace 59.94 Hz(VD) 50 Hz(VD) More than 540 TV Lines More than 48 dB 0.
D120P-C1.COMMON_MFL62723790_ENG13 13 2010.6.
D120P-C1.COMMON_MFL62723790_ENG14 14 2010.6.
D120P-C1.COMMON_MFL62723790_ENG15 15 2010.6.
D120P-C1.COMMON_MFL62723790_ENG16 16 AB28 2010.6.
