User guide

Installation

Connecting Display device

The video signal connection between the camera and the

monitor.

Display device connection

ALARM input connection

You can connect up to 4 alarm sensors to the camera. Each

alarm sensor should be connected with Alarm IN COM. You

can adjust the signal state to NO (normally open) or NC

(normally closed) through the setup menu.

For LCP2850I-AN/AP

1. Connect the RJ-45 Adaptor cable to the PORT A (RJ-45)

cable of the camera.

2. Connect the alarm device to the RJ-45 Adaptor cable.

When connecting lines, check and connect the color

lines of the each device correctly. Refer to the below

tables for color line information.

Do not connect one alarm sensor to the several

camera’s alarm input connector.

Caution

Alarm input connection

PORT ARJ-45 Adapter cable

Alarm device

RJ-45 Adaptor cable

PORT A

Alarm device

RJ-45 Adaptor cable

No Description Color

RS-485 + White

RS-485 - Orange

NC Black

ALARM IN COM Red

ALARM IN 1 Green

ALARM IN 2 Yellow

ALARM IN 3 Blue

ALARM IN 4 Brown