Owner’s Manual
Table Of Contents
- IMPORTANT SAFETY INSTRUCTIONS
- PRODUCT OVERVIEW
- INSTALLATION
- Before Installing
- Installing the Cooktop
- Electrical Connections
- Important Safety Instructions
- Providing the Electrical Connection
- Electrical Requirements
- Electrical Connection
- Where Local Codes Permit Connecting the Appliance-Grounding Conductor to the Neutral (White) Wire
- If Cooktop is Used in a New Branch Circuit Installation (1996 NEC), Mobile Home, Recreational Vehicle, or where Local Codes Do Not Permit Grounding to the Neutral (White) Wire
- Installing the Cooktop Unit
- Final Check
- Electrical Connections
- OPERATION
- MAINTENANCE
- TROUBLESHOOTING
- LIMITED WARRANTY
16 INSTALLATION
Installing the Cooktop Unit
1 Visually inspect the cooktop for damage.
Make sure all cooktop screws
a are tight (see
below for locations).
2 Check and prepare the installation location.
•See Dimensions and Clearances.
3 Carefully lower the cooktop into the
countertop cutout, making sure not to trap
any wires.
NOTE
• Do not use caulking compound. The cooktop
must be removable, should service be required.
4 Attach the retainer brackets a to the bottom
of the cooktop; then snug the bolts against
the bottom of the countertop as shown.
NOTE
• The retainer brackets MUST be installed to meet
local codes or, in their absence, with the National
Electrical Code ANSI/NFPA No. 70, latest edition.
a Cooktop
b Countertop
c Bolt
d Retainer Brackets
e Type A Screw
Alternative installation
LCE3010SBE
LCE3610SBE
a
Retainer Brackets
b Front
c Rear