Owner’s Manual
Table Of Contents
- IMPORTANT SAFETY INSTRUCTIONS
- PRODUCT OVERVIEW
- INSTALLATION
- Before Installing
- Installing the Cooktop
- Electrical Connections
- Important Safety Instructions
- Providing the Electrical Connection
- Electrical Requirements
- Electrical Connection
- Where Local Codes Permit Connecting the Appliance-Grounding Conductor to the Neutral (White) Wire
- If Cooktop is Used in a New Branch Circuit Installation (1996 NEC), Mobile Home, Recreational Vehicle, or where Local Codes Do Not Permit Grounding to the Neutral (White) Wire
- Installing the Cooktop Unit
- Final Check
- Electrical Connections
- OPERATION
- MAINTENANCE
- TROUBLESHOOTING
- LIMITED WARRANTY
20 OPERATION
Control Panel
Control Panel Features
Locations of Surface Elements and Controls
The surface burner elements are positioned in the same locations on the cooktop and the control panel for
ease of use.
Before Using the Cooktop
Before using the cooktop for the first time, clean it
thoroughly with the included cleaner or ceramic
cooktop cleaner according to the Care and
Cleaning instructions in this guide. This will help
protect the ceramic surface and make future
cleanup easier.
LCE3010SBE LCE3610SBE
LCE3010SBE LCE3610SBE
a
Warm: Lowers the selected active element to the lowest setting.
b
Hot surface indicator: The indicator light below Hot will illuminate when the cooking area is hot. It
will remain on, even after the control is turned off, until the area has cooled.
c
Control Lock: Press and hold for 3 seconds to activate and deactivate the Control Lock function.
d
Warm: Indicates that a surface burner has been set to Warm.
e
Single element, left front element
f
POWER ON/OFF: Press POWER ON/OFF to turn the entire cooktop ON and OFF. When it is ON,
the cooktop is in standby mode until an element is activated. Set the power level for an element
by selecting a number from 1 to 9 in the element power settings.
g
Dual element, right front element
h
Dual element indicator
i
Warming zone
j
Single element, center rear element Triple element, center rear element
k
Single element, left rear element Dual element, left rear element
l
- Triple element indicator