Owner’s Manual

Table Of Contents

11INSTALLATION

ENGLISH

Dimensions and Clearances

• Check the dimensions of the appliance and the installation path to ensure there is sufficient room to

move the refrigerator through doors or narrow openings.

• The installation location chosen for the refrigerator should allow space behind the unit for connections

and airflow and space in front to open the doors and drawers.

• Too small of a distance from adjacent items may result in lowered freezing capability and increased

electricity consumption charges. Allow at least 2 inches (50 mm) between the back of the refrigerator

and the wall.

• Remember to allow enough room in front of the refrigerator to fully open the doors.

Reversing Doors and

Leveling

Reversing Doors

This feature is only available on some models.

Your appliance is designed with reversible doors

which can be assembled to open from either the

left or right side to suit your kitchen design.

Door reversal must be done by an authorized

installer or service person. If it is not, any damage

caused by improperly installed doors will not be

covered by the warranty.

Leveling the Refrigerator

The refrigerator has two front leveling legs. Adjust

the legs to alter the tilt from front-to-back or side-

to side. If the refrigerator seems unsteady or the

doors do not close easily, adjust the refrigerator’s

tilt, using the instructions below:

1 Turn the leveling leg to the left to raise that

side of the refrigerator or to the right to lower

- Dimension/Clearance

LBNC15231*, LBNC15241*,

LBNC15251*

A Depth without Handle 27 5/8" (700 mm)

B Width 27 5/8" (700 mm)

C Height to Top of Case 66 1/8" (1680 mm)

D Height to Top of Hinge 67 3/4" (1720 mm)

E Back Clearance 2" (50 mm)

F Depth without Door 23 3/8" (595 mm)

G Depth (Total with Door Open 90°) 51 3/4" (1315 mm)

H Front Clearance 33 1/2" (850 mm)