PREMTC00U Installation Manual

12
OPERATION INSTRUCTIONS - Standard Operation
ENGLISH
OPERATION INSTRUCTIONS - Sub Function
13
ENGLISH
1 Press button to select auto mode.
2 Press buttons and then temperature
will blink.
3 You can control the blinking temperature
by pressing bottons.
This function automatically manages room
temperature based on set temperature and
provides a comfortable environment.
1 Press button for 3 seconds, you can
operate/cancel setback.
h You cannot change the setting in setback
operation, except to cancel the mode.
- ‘HL’ lock is displayed on the window.
Auto operation (Single set point)
NOTE
!
• When remote controller has a
connection with indoor unit that does not
support 'dual setpoint', thermal
operation function of indoor unit is
replaced with ON/Off control from the
wired remote, when the user sets target
temperatures in the below ranges.
- cooling target temp. range :
87~99 °F (30.5~37.5 °C)
- heating target temp. range :
40~59 °F (4~15.5 °C).
For the case of cooling only model, you can
adjust the temperature from hot to cold, from
"-2" to "2" based on "0".
2 : When cold
1 : When cool
0 : When appropriate
-1 : When warm
-2 : When hot
1 Press button for 3 seconds, you can
operate/cancel override.
h You cannot change the setting in override
operation, except to set sub function and
cancel the mode.
- ‘HL’ lock is displayed on the window.
- It is only applied for ‘UNOCCUPIED’.
Heating operation state
Override
The override operation temporarily returns to
the set temperature until the override
operation is canceled.
Setback
The setback operation returns to the set
temperature until the setback operation is
canceled.
OPERATION INSTRUCTIONS - Sub Function