User Manual

- 2 -
Stacking Kit Installation Instructions
To ensure safe and secure installation, please observe the instructions below.
• Do not use stacking kit with a gas dryer in
potentially unstable conditions like a mobile
home.
Insert the front stacking kit. Push the front
stacking kit back to the stoppers of side
stacking kit.
6
Place the dryer on top of the washer by fitting
legs as shown in the picture. Avoid finger
injuries - be careful not to pinch fingers
between the washer and dryer. Slide washer
slowly backwards to the stopper of kit.
5
Secure stacking kit side bracket to the washer
with a screw on the back of bracket. Repeat
Steps 2, 3, 4 for the other side.
4
Screw on both sides of the front kit.
7
The screws included are self-tapping screws. They •
can be inserted even if there are no existing holes in
the washer.
If inserting screws where no holes exist, increase the •
torque on the screwdriver at first. Once the screw
creates the hole, lower the screwdriver’s torque to
avoid stripping the screw while tightening it.
NOTE
Do not attempt installation with one person.
Incorrect installation procedure can cause
serious accidents and physical injuries.
The weight of the dryer and the height of
installation makes the stacking procedure too
risky for one person. This procedure should be
performed by 2 or more experienced service
personnel.
To reduce the risk of injury to persons, adhere
to all industry recommended safety procedures
including the use of long sleeved gloves and
safety glasses.
warning
Stacking kit
Place washer firmly on a stable, even and
solid floor as product installation instructions
describe in owner’s manual.
1
Peel protective paper off the tape from the
stacking kit side bracket.
2
Fit the stacking kit side bracket firmly to the
side of top plate by attaching the double-sided
tape to top plate as picture shows.
3