Owner's Manual

7
Mounting
the freezer and
refrigerator
compartment
doors
Feed water
pipe
Installation
Pass the
refrigerator laterally through
the access
door as shown
in
the
right figure.
?
Automatic ice maker
operation
needs water
pressure
of 147~834 kPa
(1.5~8.5
kgf/cm2)
(That
is,
an instant
paper cup
(180 cc)
will
be
fully
filled within 3
sec.).
?
If
water
pressure
does not reach the
rating
147
kPa
(1.5
kgf/cm2)
or
below,
it is
necessary
to
purchase
a
separate pressure pump
for normal automatic
icing
and
cool water feed.
?
Keep
the total
length
of the feed water
pipe
tube below
472
inch and exercise
caution
in
bending
the tube.
If
the tube is
472
inch or
longer
it
may
cause trouble
in
water feed
owing
to the reduced water
pressure.
?
Install the feed water
pipe
tube at a
place
free from heat.
?
Connect to
potable
water
supply only.
Mount them
in
the reverse
sequence
of removal after
they pass through
the access
door.
Pass the
refrigerator
3)
Remove
keeper by rotating
it clockwise
(|)
and then remove the
upper hinge by lifting
it
up(~).
4)
Remove the
refrigerator compartment
door
by
lifting
it
up.
Remove the
refrigerator
door
Before
installation
Warning
Installation
Lower
Hinge
Upper Hinge
Keeper