Owner's Manual

6
To Install as
a
Slave Drive
To install the drive as a
Slave,
change
the
jumper setting
on the rear
panel
to SL.
Connecting
the Power Connector
Connect the
power
cable from the
computer's power supply
to the socket on the drive
unit,
fitting
the connector
firmly
into the
power
in connector. If there is no
spare power
cable available in the
computer, you
will have to
purchase
a
splitter
cable of a suitable
type.
Connecting
the Interface Connector
Connect the
40-pin
IDE cable to the back of the CD-RW/DVD-ROM
Drive,
making
sure the
coloured
(red) stripe
on the IDE cable is connected to
pin
1 on the CD-RW/DVD-ROM drive. Pin
1 is closest to the Power Connector.
Slave drive
(CD-RW/
DVD-ROM
drive)
(Jumper
set to
Slave)
Master drive
(Booting
hard
disk)
-OR-
DGITAL
AN LOG
E
POWE
R
D R
CS
SL
GL
G
5
12 GND
2
UDO
UDIO
Primary
connector
Secondary
connector
Master drive
(Other
IDE
drive)
Slave drive
(CD-RW/
DVD-ROM
drive)
(Jumper
set
to
Slave)
DIGIT L
N
LOG
N
ERFACE
POWER
DR
CSM
SLA
GL
G
39
5
2 GND
0
2
UDIO
UD I
O
DGIT L
N
LOG
POWER
D
R
CS
SL
GL
G
5
12 GND
2
UDO
UDIO
Master drive
(Booting
hard
disk)
DIGITAL
AUDIO
ANALOG
AUDIO
INTERFAC
E
POWER
DG
39
40
1
+5
GND
+12
2
CSM
SLA
RGL
+5
GND
+12
POWER
Beveled
edge up
NOTE :
Improper
connection
may damage
the
drive and void the
warranty. Generally,
the
power
connector can
only
fit one
way.
DIGITAL
AUDIO
ANALOG
AUDIO
INTER
FA
CE
POWER
DG
39
40
1
+5
GND
+12
2
CSM
SLA
RGL
Pin1
Red-edge
NOTE :
Generally,
the IDE connector is
keyed
and will
only
fit one
way.