GCC-4520B EnglishDeutcFraIopP
CAUTION The laser used in the CD-RW/DVD-ROM drive : Do not attempt to open the To reduce the risk of electric No user-serviceable Refer servicing to Use of controls or shock, do parts inside. qualified can damage your eyes. cover. service performance of not remove cover (or back). personnel. procedures other than those specified herein may result in hazardous radiation exposure.
This product is manufactured to comply with the radio interference requirements 89/336/EEC, 93/68/EEC and 73/23/EEC. of EEC DIRECTIVE CAUTION - INVISIBLE LASER RADIATION WHEN OPEN AVOID EXPOSURE TO BEAM. VARNING-OSYNLIG LASERSTRALNING NAR DENNA DEL AR OPPNAD STRALEN AR FARLIG.
Contents Introduction Features........................................2 ImportantPrecautions.............................3 SystemEnvironment..............................4 LocationandFunctionofControls...................5 Installation InstallingtheDrive...............................6 DeviceDrivers..................................11 Operation HowtoUsetheDiscs............................12 Appendix Troubleshooting.................................13 ReadSpeedControlforCD-RDataCD. . . . . . .
Thank you for this purchasing CD-RW/DVDROM Drive. Features ? Enhanced-IDE ? Power disc (The ? interface. can also be ejected manually.) Combination CD-R/RW and DVD-ROM Drive functions into UDF for easy Supports ? Supports Region playback ? Supports Windows 95, 98, 2000, ME & XP/NT4.0. ? Supports Mt. Rainier. ? * writing Automatic buffer underrun 52X max 16X max Writing (CD-R), As a prevention technology-SuperLink max ReWriting (CD-RW), and 52X max Reading (CD-ROM)*.
Important Precautions Follow these Precautions ? when handling the drive or discs. Please take notice that the manufacturer of this offer any or ? precautions warranty against data loss due handling, or direct or indirect equipment does not inappropriate installation to damages. Please take notice that the manufacturer will bear for direct or indirect damages caused by the no responsibility product or its of this use malfunction.
System Environment Computer This unit can System requirements be operated in the system environment explained here. 350MHz CPU (or faster) Pentium (for high speed, faster recommended) 500MHz Memory or Windows 95/98 : 64MB or greater. Windows NT Workstation Ver. 4.0: 64MB (128MB recommended) Windows 2000:64MB or greater(128MB recommended) 75MB Hard disk or more free space. for (The free space needed quantity of data.) Secondary 5.
DirectCDTM v2.5b(s) Introduction Location and Function of Controls Front Panel 6 5 12 1. 3 4 Headphone Jack 2. Volume Control 3. Emergency Eject Hole Stop/Eject Button 5. Disc Tray 6. Drive activity indicator (Read/Write) 4. Rear Panel POWER INTERFAC E DIGITAL AUDIO ANALOG AUDIO CSM RGL 123 1. 3. GND +12 4 5 Digital Audio Output Connector Analog Audio Output Connector Jumper Connector This jumper Changing 4. +5 2 SLA DG 2.
DirectCDTM v2.5b(s) Installation Installing Before Before the Drive the installing drive, please You will need the Installation ? A screw note the following points. following: driver of a suitable size to fit the securing computer, find the screws for the drive unit. ? The manual for the positions so you can mounting for the IDE controller cable. Turn off all peripheral appliances of the computer and the computer itself, and disconnect their power cords from the wall sockets.
DirectCDTM v2.5b(s) Installation Before Jumper Setup installation, The drive set the jumper be connected can interface. When several (up must be set in way. a unique connector the Master on the or Slave panel. rear EIDE (ATAPI) four) EIDE devices are connected, each Specific knowledge of hardware and as on an to software is necessary to install the drive.
DirectCDTM v2.5b(s) Installation The CD-RW/DVD-ROM drive connects to the motherboard of the host PC Connection computer using ROM Drive To Install as a an as a To install the drive Master Drive the IDE interface cable. You may connect the CD-RW/DVD- Slave Master or as a device, depending Master, the jumper can on your be left computer. from supplied as factory.
DirectCDTM v2.5b(s) To Install Installation To install the drive as a panel Slave Drive Slave, change the jumper setting as a on the rear to SL.
DirectCDTM v2.5b(s) Installation Connect the Connecting the Interface connected to Connector IDE cable to the back of the CD-RW/DVD-ROM 40-pin Drive, making the coloured sure pin 1 on (red) stripe on the IDE cable is the CD-RW/DVD-ROM drive. Pin 1 is closest to the Power Connector. NOTE : Generally, the IDE connector is POWER DIGITAL AUDIO DG ANALOG AUDIO CSM SLA INTERFACE GND +5 1 keyed and will only fit one way.
Device Drivers When using Windows 95/98/2000/Me/XP or Window NT Workstation no special device driver is required. Your system, upon Power On and bootup after installing and connecting the new CD-RW/DVD-ROM drive, will recognize and load native software drivers automatically. Ver.4.0, The DOS and Windows 3.1 anytime users can download the DOS Device drivers via internet. For your information, please consult the following http://www.lge.com http://www.lgeservice.com/drivers.
DirectCDTM v2.5b(s) Operation How to Use the Discs When CD-ROM using discs, CD-R discs, DVD discs or CD-RW discs, don't attach any stickers or labels to the discs. Using discs with them attached not only causes read and write errors, but data on the disc may be lost due to damage to the disc itself.
Troubleshooting Before Before ? Requesting Service ? calling for service, check this list. The drive doesn't have power. ? Is the power ? Is the Power Connector to the drive The ? supply system doesn't Are the cable from the host computer plugged in? securely attached? start.
Read Speed Control for CD-R Data CD The basic default reading speed for CD-R disc media in this drive is 40X. The Read Speed Control will allow you to select the maximum read speed (52X) for CD-R media, simply by pressing the eject button. Note that this function is only available with a CD-R data disc.
Specifications CD/DVD/CD-RW Items General Supported Discs *Read Function CD-ROM, CD-ROM XA, Audio CD, Mixed Mode (Audio and Data Combined), CD-I FMV, Video CD, Photo CD (Single -Session), CD-Plus/CD-Extra, CD-Text DVD-Single/Dual, DVD-R/RW, DVD+R/RW and Multi *Write Function CD-ROM, CD-ROM XA, Audio CD, CD-I FMV, Video CD, CD-Plus/CD-Extra Disc Diameter 12cm/ 8cm, standard size CD's Host Interface E-IDE/ATAPI Read/Write Write Speed (CD-R, max 52X) : 4X, 8X, 16X, 24X, 32X, 40X, (CD-RW, max 24X
ⓒ 2003 Copyright Caution! The disc rotates at high speed in the drive unit. Use of worn, damaged, or non-standard CD-ROM discs can only adversely affect the drive and cause the disc to LG Electronics U.S.A. Inc. 1000 Sylvan Ave. Englewood Cliffs NJ 07632 U.S.A. or shatter http://www.lgeus.com or crush while in Disc crush only can use. occur when you CD-ROM disc in the drive. It is LG Electronics Canada Inc. 550 MATHESON Blvd. East Mississauga.
